Application Details
The Application was done with a low power system in the lab. The recommendation for this process would be for a minimum of 100watt laser for projected cutting speeds of 1mm per second.
100-watt laser projected 50mm plus per second.
200-watt laser projected 100 mm plus per second cutting speeds.
Process | Laser cutting |
Material | Acrylic |
Industry | Automotive |
Laser Type | CO2 |
Laser Power | 100 W |
Laser Frequency | 5 kHz |
Focal Length | 5 inches |
Depth | through |
Speed | 50 mm/sec |
Passes | 1 |
Laser Used | SBM1200 |
Application Details
This acrylic sample was processed using the SBM 1200M cutting system equipped with a 150 Watt CO2 laser and a 5.00″ lens. The samples were cut using the artwork provided by the customer.
Process | Laser cutting |
Material | Acrylic |
Industry | Manufacturing |
Laser Type | CO2 |
Laser Power | 200 W |
Laser Frequency | 5 kHz |
Focal Length | 5 inches |
Depth | through |
Speed | 10mm /sec |
Passes | 1 |
Laser Used | SBM1200 |
Application Details
The sample was cut through all 3 layers completely and consistent at a speed of 250mm per second. however, with a smaller focus lens, it is possible to increase its speed up to 300mm/sec. Two protection films (clear and green) produce a great amount of smoke and residue while cutting, which contaminates the sample very strongly. No cleaning was performed on the sample after cutting.
Process | Laser cutting |
Material | Acrylic |
Industry | Manufacturing |
Laser Type | CO2 |
Laser Power | 250 W |
Laser Frequency | 10 kHz |
Focal Length | 5 inches |
Depth | through |
Speed | 250 mm/sec |
Passes | 1 |
Laser Used | Titan FX |