676
Sample Name: “Crowne plaza Invitational” logo Working Distance: 175mm Material: Stainless steel Power: 100% (20W average) Method Used: Laser marking Frequency: 20kHz Depth: ~0.3mm Speed: 300mm/sec Laser Type: Pulsed fiber laserRead More…
Sample Name: “Crowne plaza Invitational” logo Working Distance: 175mm Material: Stainless steel Power: 100% (20W average) Method Used: Laser marking Frequency: 20kHz Depth: ~0.3mm Speed: 300mm/sec Laser Type: Pulsed fiber laserRead More…
Sample Name: “Dallas national golf club” logo Working Distance: 175mm Material: Stainless steel Power: 100% (20W average) Method Used: Laser marking Frequency: 20kHz Depth: ~0.3mm Speed: 300mm/sec Laser Type: Pulsed fiberRead More…
UID marking a two-dimensional data matrix with 3mil data cell size was marked on polished plate stainless steel stock. The mark produced had excellent contrast. Total marking time was 0.6 seconds. ARead More…
A UID data matrix with 3mil data cell size was laser marked on polished stainless steel stock. The mark produced had excellent contrast. The total mark time was 0.5 seconds. A 20 WattRead More…
Laser engraving of this wooden block sample was done using a 100-watt CO2 laser through a 300mm lens. Sample Name: wood brick Working Distance: 220mm Material: wood Power: 60%-98% Method Used: LaserRead More…
Laser engraving of this wooden block sample was done using a 100-watt CO2 laser through a 300mm lens. Sample Name: wood brick Working Distance: 220mm Material: wood Power: 60%-98% Method Used: Laser EngravingRead More…
Deep engraving was done on this red brick sample to show the capabilities of using CO2 lasers for engraving purposes. The depth and speed at which the process can be done simplyRead More…
Laser marking of wooden door frames using a CO2 laser. Marked text was reorganized into 2 lines, so it could fit into a single working field of the recommended system (which isRead More…
Laser cutting of the dashboard inset shapes was done at a low cutting speed to improve edge quality. The sample could be cut at a much faster speed but at the sacrificeRead More…
All three different wood parts were marked with the same parameters. Markings No.1 and No.2 (green numbers on the picture above) are different only in sizes and, therefore, in cycle times. MarkingRead More…
Laser engraving / burning wood model and or serial numbers on Cabinet doors and drawer faces. 30 W @ 100% and 100-150 mm/sec. Various size cabinet doors were laser marked using the FantomRead More…
Laser marking of a simple flower pattern onto glass with a mirrored background using a CO2 laser (mirror laser marking).
Laser etching or marking of a crane vector image onto glass using a CO2 laser.
Laser marking of a butterfly photo on glass with a black background using a CO2 laser.
Laser marking of palm trees image/picture on glass with a black background using a CO2 laser.
Laser marking of a grapes image/picture on glass with a black background using a CO2 laser.
Laser marking a model image/picture on glass with a black background using a CO2 laser.
Laser marking a pagoda image/picture on glass with a black background using a CO2 laser.