All three different wood parts were marked with the same parameters. Markings No.1 and No.2 (green numbers on the picture above) are different only in sizes and, therefore, in cycle times. Marking No.1 is done in 1.0 seconds, No.2 is done in 0.75 seconds.

Sample Name: Wood pieces Working Distance: 300mm
Material: Different wood Power: 100% (100W)
Method Used: Laser marking Frequency: CW-mode
Depth: Not measured Speed: 500mm/sec
Laser Type: 100W CW CO2 laser Passes: 1
Focal Length Lens: 300mm Cycle Time: 1.0sec / 0.75sec