The parts were marked using a 10 & 20 Watt Fiber Laser Marking System using a 160 mm lens. The parts were marked with both an etched mark and a dark surface mark. The etched marked was done using the 10 Watt Fiber laser and had a cycle time of 0.45 seconds. The dark surface marks were done with a 20 Watt Fiber Laser, the cycle time was 0.45 seconds. The two different types of marks were done to show variety and to provide more than one marking option. The parts were also marked while covered in the lubricant that was in the bag that the parts came in. The parts were not wiped off before being marked.